Product thermal capacity : 1-20 t/h Working pressure : 0.7-2 Mpa Available fuel : Nature gas, coke oven gas, biogas, methanol, liquid propane gas, diesel, heavy oil, light oil, crude oil, etc. Available industries : Heat supplying, chemical, food, textile, printing and dyeing, cigarettes and tobacco, fodder, pharmacy, building materials, brewery, rubber, hospital etc. Introduction:
power plant experience letter boiler dcs is a boiler shell type 3 passes wetback oil/gas fired boiler. After fuel is being atomized by burner, flame is full of the wave furnace and transfer heat via furnace wall, this is 1st pass; the high temperature smoke is collected in reversal chamber and then enters 2nd pass which is grooved tubes bundle area; after heat convection, air temperature gradually falls and goes to front smoke box and turn to 3rd pass, which is smooth tubes bundle area, and then enters chimney passing back smoke box and exhausted to the atmosphere.
Technical advantages Digitized manufacture
The key part such as material cutting, rolling, drilling are proceeded by advanced CNC machining process to reduce the assemble stress and extend boiler working lifetime.
The front and back smoke chamber plates are cut by CNC plasma cutting machine and looks tidy and beautiful.
Easy operation and maintenance
Fully automatically operating, with automatically adjustment and protection of burning, water level, temperature and steam pressure.
Longer working life
Smoke tube and tube sheet connection is expanded first to eliminate the gap between them, then adopt automatic argon arc welding to relief the stress and expand boilers working life.
Longitudinal and girth joint adopt advanced automatic submerged-arc welding for good welding quality. All longitudinal and girth joint will have 100% radiographic inspection.
Fin tube us ND steel or stainless-steel material which avoid low temperature corrosion.
Inspection procedure point is set up to guarantee the sequence of expanding and welding, avoid cracking of the tube sheet holes.
Less fuel consumption
High quality aluminum silicate fiber is used with fire clay insulation, to control the boiler body temperature below 45℃ to control heat lost.
Sufficient steam storage room and heating area makes boiler to generate high quality steam and high thermal power.
Condenser is added to reuse the waste heat of the exhausted smoke to increase feeding water’s temperature and reduce emission temperature, which can increase the thermal efficiency above 98% and save operating cost.
A minimum of 2 years of power plant operating experience or. A minimum of 5 years of power plant experience (maintenance, engineering, etc.) Experience with power plant processes (boilers, turbines, generators, auxiliary equipment and water chemistry) DCS and basic computer proficiency Ability to work in a flexible team environment
Boiler name: power plant experience letter boiler dcs Boiler Distributor：Our product range includes biomass fired thermal fluid heaters, coal fired hot oil boilers, oil/gas fired thermal fluid heaters and molten salt heaters.
Operate a circulating fluidizing bed boiler, G.E. turbine generator and auxiliary equipment to produce 26 megawatts production. Monitor plant operations and maintain emissions data, responds to plant conditions to maximize plant efficiency and safety. Member of the Voluntary protection program. Perform lock out, confined space and hot work permits
A distributed control system (DCS) is a computerised control system for a process or plant usually with a large number of control loops, in which autonomous controllers are distributed throughout the system, but there is central operator supervisory control. This is in contrast to systems that use centralized controllers; either discrete ...
An obsolete control system for the Central Utilities Plant was migrated to a modern DCS. Plant control systems that were upgraded include combustion burner management interface, balance of plant, combustion turbine, electric and steam chiller, cooling tower and electrical switchgear. POWER was selected as owner’s engineer/commissioning
Power Plant Engineer. Operated high pressure steam boilers, steam turbo generators and all related equipment for 500 megawatt power station. Served on restart QA/QC team of the Conners Creek power plant inspecting boiler feed pumps, condensate return and condensate circulating pumps and related valves and piping.